Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGhost Controls Keypad & Intercom Repair: The Duncanville Owner’s Guide
Ghost Controls keypad and intercom repair in Duncanville typically runs $165 to $320 installed, and we stock the parts on our trucks so most calls are finished the same day. The part itself is usually a failed keypad membrane, a corroded control board inside the intercom housing, or wiring that Texas sun and soil have eaten through. Most owners notice it the way you would expect: the gate ignores the code, the intercom crackles and drops the call, or the whole keypad goes dark with no warning.
Victor Salinas has seen this failure enough times in Duncanville to know the pattern. The keypad sits outside in full sun off Clark Road, the heat works on the membrane until it turns brittle, and one morning the buttons stop responding. The gate still opens from the remote or the app, so the owner puts up with it, and then a visitor arrives, and suddenly the keypad matters again. That is usually when the phone rings. Tell me what it is doing, or not doing, and we will go from there.
Which Ghost Controls Models This Applies To
This repair guide applies to the Ghost Controls gate opener series most common in Duncanville driveways: the AXDP, AXD, and TSS1 lines, along with the Ghost Controls wireless keypad (model AXWK) and the intercom-ready keypad built for the AXI intercom system. The quickest way to confirm what you have is to look at the back of the keypad housing. Ghost Controls stamps the model number on the rear plate, and the keypad itself is black with gray buttons on most versions, a detail that helps because aftermarket copies are now common in Texas supply houses.
One compatibility gotcha worth knowing: Ghost Controls keypads use a proprietary 3-wire communication protocol. A generic garage-door keypad from a big-box store will not talk to a Ghost Controls board, even if the voltage looks right. If someone sold you a universal keypad as a replacement, that is likely why it never worked. We install OEM Ghost Controls keypads or quality equivalents that match the exact protocol. We also service the intercom line, where the AXI intercom module pairs with a door station that shares the same weatherproof housing. Ironworks Gate Co. is an independent service provider and is not affiliated with Ghost Controls, but we know these parts well because we have been replacing and repairing them around Duncanville for years.
Signs Your Ghost Controls Keypad & Intercom Repair Is Failing
- Keypad accepts the code but the gate does not move. This usually means the keypad is sending a signal but the control board is not hearing it. In Duncanville’s summer heat we often find a swollen capacitor on the receiver side of the board, not a bad keypad at all.
- Buttons respond only after being pressed hard or multiple times. The silicone membrane under the buttons is worn. Ghost Controls keypads last about 5 to 8 years in full Texas sun before the membrane goes stiff. Rain and humidity around Duncanville creeks speed that up.
- Intercom audio is crackling, cutting out, or one-way. Most often the microphone on the door station has corroded. The housing is weather-resistant, not weatherproof, and years of Dallas County dew take a toll on the contacts.
- Keypad is completely dark at night. Ghost Controls keypads have a backlight that should glow softly when the keypad is awake. If the backlight is dead, the panel has lost power or the board is shorted. That is not a battery issue on wired models.
- Code works sometimes but not others, especially after a rain. Water intrusion into the keypad housing causes intermittent shorts. We find this often on gates that face north where the keypad never gets the drying heat of the afternoon sun.
Replacement Cost & What’s Included
A Ghost Controls keypad replacement in Duncanville runs $185 to $280 installed with an OEM or matched quality keypad. A full intercom repair, meaning the door station and the indoor handset module, runs $220 to $420 depending on whether the wiring is intact or needs to be re-pulled. These are the numbers we quote before we start, and the price you agree to is the price on the invoice. No add-ons, no surprise charges.
The range depends on access. A clean swap at a keypad mounted beside a gate on a well-kept yard is the low end. A keypad mounted in a brick pillar where the carpenters gave us no extra wire is the high end, because the fishing takes time. Every quote includes the part, the labor, a full function test, and our 90-Day Done Right Promise in writing. We also carry the Ghost Controls intercom door station and the indoor module, so there is no second trip waiting for parts that are not on the truck.
Key Takeaways
- We stock Ghost Controls keypads, door stations, and intercom modules on our trucks in Duncanville.
- Most keypad or intercom repairs are done in a single visit, same day.
- Upfront pricing is settled before any work starts, and the price does not change.
- Generic garage-door keypads will not run a Ghost Controls system.
- We are independent of Ghost Controls, so no dealer overhead or markup games.
DIY or Call Us?
There is one thing worth checking yourself, and it only takes two minutes. Look at the keypad after a rain or after a cold night and see whether condensation is visible under the faceplate. If there is moisture trapped inside the housing, you have found the reason the buttons are misbehaving. Take a photo of it, because it helps us know whether the board has been wet for months or just a day. That is the extent of the safe DIY work here.
Opening the keypad housing is where we would stop you, and not to protect the job. Ghost Controls keypads are wired into the same low-voltage system as the control board, and shorting the wrong lead can fry the board. A replacement control board runs over $300 before labor, so a five-minute tinker can turn a $200 keypad job into a much bigger bill. If the keypad or intercom is intermittent, dark, crackling, or silent, call us at (903) 532-2236 and we will sort it out.
FAQs
A Ghost Controls keypad lasts 5 to 8 years in Duncanville’s heat before the membrane or board fails, and an intercom door station lasts 6 to 10 years if it is not hit with irrigation water. South-facing keypads age faster, which is why we always ask which way your gate faces when you call for a quote.
Sometimes we can, and we will tell you straight if the failure is a wire, a connector, or a cleanable contact instead of a dead membrane. But a worn membrane or a corroded board is a replacement, not a repair. The honest answer is that we replace far more of these than we repair, and we do not charge you to look and tell you which one you have.
A keypad swap takes 45 minutes to an hour once we are on site, and an intercom replacement is usually 90 minutes unless the wiring needs to be re-pulled. Most Duncanville customers are back to a working gate before lunch.
We stock Ghost Controls keypads, door stations, and intercom modules on our trucks, along with keypads and intercom parts for LiftMaster, Mighty Mule, and DoorKing, because the last thing a Duncanville homeowner needs is a second service call for a part that was not ordered until the first call happened. If we quote you a repair, the part is already on the truck.
Call Ironworks Gate Co. for Ghost Controls Keypad & Intercom Repair in Duncanville
If your Ghost Controls keypad is dead, intermittent, or the intercom has stopped talking back, call (903) 532-2236 for a free estimate and an honest answer. We have been serving Duncanville since 1984, and we background-check every technician who steps onto your property. Ask for Victor Salinas, and we will have a truck at your gate with the right part on board. Done right, and backed in writing.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Duncanville and nearby areas.